Our DTC BUMP AMP Series For SOLID STATE LESLIE™ Models.

If you are serious about boosting the total wattage output capabilities of your SOLID STATE
LESLIE model then take a look around inside your Leslie to see what configuration best
suits your needs... there is room and it can be used to your sound advantage!

REMEMBER... You can only use (1) DTC-4070-BA Bump Amp with (1) DTC-4070-PA Power Amp!

WARNING: your LESLIE Speakers may need to be replaced with higher wattage speakers
ONLY if you intend to crank up the Gain Control.

NOTE... the original Leslie Power Supply may not be able to handle the total increase
of the new power amplifier loads if you crank up the GAIN Control.
The power supply may need to be "beefed" up to support the new DC voltage & current
requirements if you intend to push our DTC Power Amps to the "X-SCREAM".
Contact Us about upgrading your Power Supply!

The picture below is a typical layout for the majority of LESLIE models manufactured. Your
model may have slight variations to contend with. Still... you can use this picture to get a
good idea of how many BUMP AMPS you may want to use and where you would like to place
them for proper working capabilities.

Please note that depending on your Leslie model the Metal Back Panel may have 1 to 6 amps
mounted on it. Those amps may be mounted in a horizontal or vertical pattern to each other.
Those 1 to 6 original amplifiers can be "directly" replaced with our DTC Series of Power Amps.

If your model only has 1 or 2 original power amplifiers mounted on the Metal Back Panel and
there is space left on the Metal Back Panel without any interference with the Power Supply or
Rotor when closed up, then you may have the option of using our DTC-4070-BA-SRM Bump Amp
with its aluminum base plate and 24" Leads for mounting in locations "A" or "B" as shown.

If your model has 1, 2, 3, 4 or more original power amplifiers mounted on the Metal Back Panel
then all bets are off for mounting our Bump Amps there. So that is where our DTC-4070-BA-LRM
Bump Amp comes in. With the aluminum base plate and 48" leads that are included you can
now opt for mounting our DTC-4070-BA-LRM Bump Amp in a variety of locations in areas 1 to 8
as shown. Then again you may become creative and find other internal places to mount them.

DISCLAIMER:
WE RECOMMEND THAT ALL DTC POWER AMPLIFIER INSTALLATIONS AND CALIBRATIONS BE PERFORMED BY A QUALIFIED AND/OR CERTIFIED
ELECTRONICS SERVICE TECHNICIAN FAMILIAR WITH THE HAMMOND/LESLIE BRAND OF EQUIPMENT. WE ASSUME NO RESPONSIBILITY OR
LIABILITY NOR WILL WE ACCEPT ANY LIABILITY OR RESPONSIBILITY FOR DAMAGES ASSOCIATED WITH THIS PRODUCT CONCERNING MISUSE,
INCORRECT OR FAULTY CONNECTIONS, INCORRECT INSTALLATIONS, IMPROPER USE AND/OR INCORRECT ADJUSTMENTS OF OUR DTC POWER
AMPLIFIERS. WE STRONGLY RECOMMEND THE ORIGINAL SPEAKERS BE REPLACED WITH HIGHER WATTAGE CAPABLE SPEAKERS THAT EXCEED
THE CONTINUOUS MAXIMUM OUTPUT WATTAGE RATINGS OF OUR DTC POWER AMPLIFIERS.
PLEASE REFER TO OUR LIMITED WARRANTY FOR MORE DETAILS!

DOUG TAYLOR CONTROLS LLC IS NOT AFFILIATED WITH HAMMOND™, LESLIE™, OR HAMMOND SUZUKI™

HAMMOND™, LESLIE™ are registered Trademarks of HAMMOND SUZUKI™