NEW for 2011... the DTC-DMOS series MOSFET Power
Amplifiers!
CHECK OUT
THE FEATURES...
Replaces the existing power amplifiers using the
original (4) mounting screws, the original Audio Signal Input connection, the
original Speaker output connection & the original 5 pin Power Supply
connection!
NO back pan remote mounted output transistors or sockets
required!
NO bulky output transistor wiring harnesses required!
NO
power supply changes required!
(Unless you order to
much amplification for your existing power supply to handle!... If so then check
out our PSU Power Supply upgrades to your existing chassis... YES, our
power supplies make sure your new amps KICK-ASS!)
100,
150 & 200 watt RMS output into 4, 8, or 16 ohm speaker load (see
below)
Low Noise & Low Distortion 0.1% THD typical for frequency range of
20Hz to 25kHz
Thru-Back Panel Input GAIN Control for easy
adjustment
Automatic STAND-BY feature on Power Up and Power Down... NO
Speaker Inrush Thumps or Pops
Vacuum Tube Output Emulation using DMOS
technology for soft clipping... similar to vintage tube type
amplifier
Over Current Power Supply Protection
Output Short Circuit
Protection
Internal Thermal Shutdown Protection
Fan Cooled Modular Heat
Sink designs
Clip Limit Detection - Optional
EACH DTC-DMOS design is on an easy to
install and plug connect circuit board.
FULL RANGE Output Power Amplifier (for standard upgrade
replacements)
Part #: DTC-FR-100DMOS... 100 watts
RMS for 4 or 8 ohm load... See PURCHASE Page for $$$!
GET
SERIOUS... go for the ULTIMATE DTC-DMOS UPGRADES!
Great
for numerous multi-amp / multi-channel solid state Leslie's!
(Some
examples: 715, 722, 760, 815, 822, 860, 925 and
X77)
HORN - High Efficiency with Selectable Tube
Emulation for High Performance Hi-Frequency Demand Applications...
Part
#: DTC-HR-150DMOS... 150 watts RMS for 4 or
8 ohm load... See PURCHASE Page for $$$!
MID RANGE (Keyboard
& Drum) - for High Performance "Lo Mid-Middle-Hi Mid" Frequency
Demand Applications...
Part #: DTC-MR-100DMOS...
100 watts RMS for 4 or 8 ohm load... See PURCHASE Page for $$$!
LOW
& SUB (Bass & Pedal) - for High Performance "Lo-Frequency
& Sub-Woofer" Demand Applications...
Part #: DTC-LR-200DMOS... 200 watts RMS PARALLED for 4, 8 or
16 ohm load... See PURCHASE Page for $$$!
Go to PURCHASE page...
DOUG TAYLOR CONTROLS LLC IS NOT
AFFILIATED WITH ANY MANUFACTURER or BRAND NAMES UNLESS NOTE AT THE
MANUFACTURERS WEB SITE.
© Copyright
2006-2011 DOUGTAYLORCONTROLS.COM, DOUG TAYLOR CONTROLS, LLC
All Rights
Are Reserved, TM and ® indicates a Registered Trade Marks throughout this
site
Terms of Use and Privacy Policy
amplifiers,amplifiers,amplifiers,solid state,solid state,solid
state,tube,tube,tube,
guitar,guitar,guitar,bass,bass,bass,keyboard,keyboard,keyboard,organ,organ,organ,stage,stage,stage,lighting,lighting,lighting,
systems,systems,systems,vintage,vintage,vintage,classic,classic,classic,